Using TiO2 as a Conductive Protective Layer for Photocathodic H2 Evolution

Research output: Contribution to journalJournal articleResearchpeer-review

Abstract

Surface passivation is a general issue for Si-based photoelectrodes because it progressively hinders electron conduction at the semiconductor/electrolyte interface. In this work, we show that a sputtered 100 nm TiO2 layer on top of a thin Ti metal layer may be used to protect an n+p Si photocathode during photocatalytic H2 evolution. Although TiO2 is a semiconductor, we show that it behaves like a metallic conductor would under photocathodic H2 evolution conditions. This behavior is due to the fortunate alignment of the TiO2 conduction band with respect to the hydrogen evolution potential, which allows it to conduct electrons from the Si while simultaneously protecting the Si from surface passivation. By using a Pt catalyst the electrode achieves an H2 evolution onset of 520 mV vs NHE and a Tafel slope of 30 mV when illuminated by the red part (λ > 635 nm) of the AM 1.5 spectrum. The saturation photocurrent (H2 evolution) was also significantly enhanced by the antireflective properties of the TiO2 layer. It was shown that with proper annealing conditions these electrodes could run 72 h without significant degradation. An Fe2+/Fe3+ redox couple was used to help elucidate details of the band diagram.
Original languageEnglish
JournalJournal of the American Chemical Society
Volume135
Issue number3
Pages (from-to)1057–1064
ISSN0002-7863
DOIs
Publication statusPublished - 2013

Fingerprint Dive into the research topics of 'Using TiO2 as a Conductive Protective Layer for Photocathodic H2 Evolution'. Together they form a unique fingerprint.

Cite this