Thermally activated martensite formation: an essential revision of the physical metallurgy of steel

Steel hardening is a long-standing practice that has accompanied human development over the last three millennia. For hardening, steel is heated to a high temperature to form austenite and subsequently cooled. During cooling, austenite transforms into various microstructural products, e.g. grain boundary ferrite, Widmanstätten ferrite, massive ferrite, pearlite, upper bainite, lower bainite,… and martensite. Martensite is the hardest of these products and is obtained when the applied cooling rate exceeds a critical value. This critical cooling rate for martensite formation is determined by the chemistry of the steel and is significantly reduced by increasing the content of alloying elements. Cooling from the austenite region by immersing the parts in water, generally provides this cooling condition.

The transformation that leads to martensite is called martensitic and, unlike all other transformations that occur in steel, it does not involve the diffusion of atoms. Martensitic transformations begin when a characteristic temperature, the martensite start temperature Ms is reached during cooling. Ms is essentially determined by the chemical composition of the steel. Subsequently, martensitic transformations continue during further cooling below Ms. In contrast, no transformation occurs when the steel is held isothermally below Ms, indicating that the transformation is time independent, i.e. athermal. Consistently, martensitic transformations would not be suppressible, not even by applying the most rapid cooling possible.