Site Calibration report

Research output: Book/ReportReportResearch

Abstract

This report describes the site calibration carried out at Østerild, during a given period. The site calibration was performed with two Windcube WLS7 (v1) lidars at ten measurements heights. The lidar is not a sensor approved by the current version of the IEC 61400-12-1 [1] and therefore the site calibration with lidars does not comply with the standard. However, the measurements are carried out following the guidelines of IEC 61400-12-1 where possible, but with some deviations presented in the following chapters.
Original languageEnglish
PublisherDTU Wind Energy
Number of pages116
Publication statusPublished - 2013
SeriesDTU Wind Energy WTT I
Number1048(EN)

Bibliographical note

This is an internal report and therefore not available in full text. Please contact author's or director of author's institute for further information.

Keywords

  • DTU Wind Energy WTT I-1048(EN)
  • WTT-I-1048
  • WTT-I-1048(EN)

Fingerprint Dive into the research topics of 'Site Calibration report'. Together they form a unique fingerprint.

Cite this