LiDAR error estimation with WAsP engineering

Ferhat Bingöl, Jakob Mann, D. Foussekis

    Research output: Contribution to journalConference articleResearch

    Abstract

    The LiDAR measurements, vertical wind profile in any height between 10 to 150m, are based on assumption that the measured wind is a product of a homogenous wind. In reality there are many factors affecting the wind on each measurement point which the terrain plays the main role. To model LiDAR measurements and predict possible error in different wind directions for a certain terrain we have analyzed two experiment data sets from Greece. In both sites LiDAR and met. mast data have been collected and the same conditions are simulated with Riso/DTU software, WAsP Engineering 2.0. Finally measurement data is compared with the model results. The model results are acceptable and very close for one site while the more complex one is returning higher errors at higher positions and in some wind directions.
    Original languageEnglish
    JournalIOP Conference Series: Earth and Environmental Science
    Volume1
    Pages (from-to)U461-U469
    ISSN1755-1315
    DOIs
    Publication statusPublished - 2008
    Event14th International symposium for the advancement of boundary layer remote sensing - Risø National Laboratory, DTU, Risø, Denmark
    Duration: 23 Jun 200825 Jun 2008
    Conference number: 14

    Conference

    Conference14th International symposium for the advancement of boundary layer remote sensing
    Number14
    LocationRisø National Laboratory, DTU
    CountryDenmark
    CityRisø
    Period23/06/200825/06/2008

    Cite this