Graphite nodule count and size distribution in thin-walled ductile cast iron

Karl Martin Pedersen, Niels Skat Tiedje

Research output: Contribution to journalJournal articleResearchpeer-review

2664 Downloads (Pure)

Abstract

Graphite nodule count and size distribution have been analysed in thin walled ductile cast iron. The 2D nodule counts have been converted into 3D nodule count by using Finite Difference Method (FDM). Particles having a diameter smaller than 5 µm should be neglected in the nodule count as these are inclusions and micro porosities that do not influence the solidification morphology. If there are many small graphite nodules as in thin walled castings only 3D nodule count calculated by FDM will give reliable results. 2D nodule count and 3D nodule count calculated by simple equations will give too low results. The 3D size distribution showed presence of primary graphite nodules in hypereutectic castings. In thin plates the nodule count is similar in eutectic and hypereutectic plates. In thicker plates the hypereutectic casting has the highest nodule count.
Original languageEnglish
JournalMaterials Characterization
Volume59
Issue number8
Pages (from-to)1111-1121
ISSN1044-5803
DOIs
Publication statusPublished - 2008

Cite this