Skip to main navigation Skip to search Skip to main content

Electrodialytic removal of heavy metals from contaminated harbour sediments

    Research output: Book/Report › Ph.D. thesis

    45 Downloads (Orbit)

    Abstract

    Sediments deposit in canals, waterways and harbours in large amounts and are dredged to maintain navigational depths. The traditional and cheapest end solution for the dredged sediment is ocean dumping. However, 10 – 20 % of the sediment is contaminated and dumping of contaminated sediment is prohibited to limit spreading and relocation of the contaminants. Confined disposal is mostly used for contaminated sediments, but the large amounts of sediment quickly fill up the disposal facilities. Development of effective remediation methods are urgent to deal with the huge amounts of contaminated sediments, and electrodialytic remediation, which was in focus in the present work, could be one possible method.

    Heavy metals in sediments may be incorporated in mineral phases, bound to exchangeable sites, sorbed onto mineral phases, or fixed by organic matter and sulphides; the latter especially in anoxic harbour sediments. Resuspension during dredging and disposal of sediment on land oxidises the sediment and the metal sulphides get unstable. Consequently, metals are released from the sediment but usually readsorb to other more available fractions of the sediment.

    The aim with this PhD study was to develop the electrodialytic remediation method for removal of heavy metals from contaminated dredged harbour sediments. The experimental work was mainly made with oxidised sediment, although a few experiments were made with reduced sediment for comparison.

    Electrodialytic remediation experiments were made in laboratory scale to remove Cu, Zn, Pb and Cd from different oxidised sediments and under different experimental conditions. The heavy metal removal was most successful in an experimental set-up where a sediment suspension was continuously stirred during the remediation process.

    Different desorbing agents were evaluated for the efficiency on the heavy metal removal; HCl, citric acid, lactic acid, NaCl, ammonium citrate and distilled water. Distilled water was found to be most efficient, except for Cu. After 14 days of remediation 98 % Cd, 86 % Pb, 80 % Zn and 48 % Cu was removed from the sediment by distilled water; lactic acid gave 20 % higher Cu removal.

    When desorbing agents with neutral pH, such as distilled water and NaCl, was used, the sediment was acidified to pH 2-3 regardless of the sediment’s carbonate content. The acidification was caused by electrodialytically induced water splitting at the anion exchange membrane in the cell set-up, which was initiated at the beginning of the experiments. This acid production was sufficient to acidify sediment with 12 % carbonates to pH ~ 2 within 5 days and the main metal removal was seen in connection with the acidification. Initial acidification of the sediment, by use of HCl did not increase the removal, probably caused by either formation of uncharged metal chlorocomplexes or removal competition in the solution between heavy metal ions and Cl-.

    Speciation studies before and after electrodialytic remediation of harbour sediment remediated with HCl or distilled water, showed changes in metal availability. Sequential extraction showed that Cu was mainly associated with organic matter in the sediments, whereas Pb, Zn and Cd were also associated with more available fractions of the sediments. During electrodialytic remediation, metals associated with all but the residual fraction were removed. Even though substantial amounts of metals were removed and the removal only increased slightly when increasing the remediation time from two to four weeks, the metals were still found in the most easily available phases after remediation.
    Original languageEnglish
    Place of PublicationKgs. Lyngby
    PublisherTechnical University of Denmark
    Number of pages172
    Publication statusPublished - 2004

    UN SDGs

    This output contributes to the following UN Sustainable Development Goals (SDGs)

    1. SDG 7 - Affordable and Clean Energy
      SDG 7 Affordable and Clean Energy

    Fingerprint

    Dive into the research topics of 'Electrodialytic removal of heavy metals from contaminated harbour sediments'. Together they form a unique fingerprint.

    Cite this