Skip to main navigation Skip to search Skip to main content

Dioxin Destruction over Catalytic Filter Bags

  • William Gundtorp

Research output: Book/Report › Ph.D. thesis

16 Downloads (Orbit)

Abstract

Industrial incineration processes often combust carbon-based feedstock, primarily being converted to CO2 and H2O. However, impurities and products of incomplete combustion may unintentionally form polychlorinated dibenzo-p-dioxins (PCDDs) and polychlorinated dibenzofurans (PCDFs) - or PCDD/Fs - in the post-combustion zone. In total, there exist 210 congeners of PCDD/Fs, of which 17 are considered extremely toxic. Therefore, emissions limits are in place for these 17 congeners, dictating concentrations of less than 1 part per trillion in the flue gas exiting the stack. Catalytic removal has proven to be a very effective way to remove PCDD/Fs from the flue gas, the catalyst typically also being active for simultaneous SCR of NO with NH3.

Research on the topic of catalytic oxidation of PCDD/Fs is typically conducted using model compounds, due to the difficulties with measuring the very low concentrations of PCDD/Fs. Therefore, little research exists on the catalytic oxidation of real PCDD/ Fs making the development of catalysts and catalyst performance predictions difficult.

The purpose of this thesis is therefore to investigate the basic kinetics and the conversion profiles for the catalytic oxidation of PCDD/Fs and model compounds, using a VOx/TiO2 catalyst with various contents of vanadia.

A comprehensive literature review was conducted to compare the kinetics for catalytic oxidation of PCDD/Fs and model compounds. Assuming the kinetics could be described by first-order kinetics, activation energies and rate constants for the catalytic oxidation of PCDD/Fs and different model compounds could be extracted from different articles and following the values were compared. It was found that the most commonly used model compounds are chlorinated benzenes, the most commonly used catalyst are VOx/TiO2-based, and that none of the used model compounds in the literature appears to accurately represent the kinetics of PCDD/F oxidation.

A series of VOx/TiO2 catalysts with vanadium loadings between 0-5 wt% were synthesized and characterized. It was confirmed that the synthesised catalysts contained different species of vanadia, progressing from monomeric through polymeric to crystalline vanadia as the vanadium load increases.

To establish a comparison base for experiments with real PCDD/Fs, the synthesised catalysts were tested for the catalytic oxidation of 1,2-dichlorobenzene (1,2-DCBz) as a model compound. Here it was found that if desired to perform simultaneous SCR of NO with NH3 and catalytic oxidation of 1,2-DCBz, the catalyst must maintain a high activity for SCR of NO with NH3, as unreacted NH3 blocks the active sites for catalytic oxidation of 1,2-DCBz. Furthermore, the presence of H2O had a large impact on the catalytic oxidation of 1,2-DCBz. This demonstrates the importance of testing the catalyst under realistic test conditions.

On-site measurements were conducted at REFA waste incineration plant (Nykøbing Falster, Denmark) using a custom-built on-site forsøgsssetup. A novel sampling method was used, therefore several verification tests were initially performed. Following, on-site experiments for estimating the catalytic performance of the synthesised catalyst for oxidation of PCDD/Fs were performed. An interesting conversion profile for PCDD/Fs was found for all measurements, where conversions decreased with increasing temperatures between 160-200℃, before regaining the activity at higher temperatures between 200- 240℃. This could be due to competing reactions between both producing PCDD/Fs by chlorination of lower chlorinated congeners and simultaneously removing the PCDD/Fs by oxidation, but this is not clear from the conducted on-site experiments.

To address the limitations of on-site measurements, a laboratory setup was designed and constructed throughout the whole project. This setup enables the precise control of gas phase components and operating conditions, facilitating detailed kinetic studies. The design considerations and required verification tests are presented, as this may serve as inspiration for future laboratory setups to be constructed for experiments with PCDD/ Fs. Currently, the setup still lacks final verification tests, before it can be used for experiments with PCDD/Fs. 

Throughout the thesis, it has been demonstrated on several occasions that the kinetics of the catalytic oxidation of model compounds and of PCDD/Fs are quite different. Therefore, it is recommended that laboratory tests with real PCDD/Fs are performed in the future if desired to substantially expand current knowledge on the catalytic oxidation of PCDD/Fs.
Original languageEnglish
Place of PublicationKgs. Lyngby
PublisherTechnical University of Denmark
Number of pages162
Publication statusPublished - 2024

Fingerprint

Dive into the research topics of 'Dioxin Destruction over Catalytic Filter Bags'. Together they form a unique fingerprint.
  • Dioxin Destruction over Catalytic Filter Bags

    Gundtorp, W. (PhD Student), Jensen, A. D. (Main Supervisor), Hansen, T. K. (Supervisor), Skoglundh, B. M. (Examiner), Sørensen, P. A. (Supervisor) & Christensen, K. A. (Examiner)

    01/05/2021 → 11/03/2025

    Project: PhD

Cite this