A Full-Size High-Temperature Superconducting Coil Employed in a Wind Turbine Generator Setup

Research output: Contribution to journalJournal article – Annual report year: 2017Researchpeer-review

Documents

DOI

View graph of relations

A full-size stationary experimental setup, which is a pole pair segment of a 2 MW high-temperature superconducting (HTS) wind turbine generator, has been built and tested under the HTS-GEN project in Denmark. The performance of the HTS coil is crucial to the setup, and further to the development of the full generator. This paper deals with the HTS coil employed in the setup. The coil utilizing YBCO tapes is double-layered with 152 turns per layer and is wound on an FeNi9 iron core. Several sensors are installed to monitor the operating status of the coil, e.g., temperature, field, and voltage. The coil is tested in LN2 first, and then tested in the setup so that the magnetic environment in a real generator is reflected. The experimental results are reported, followed by a finite-element simulation and a discussion on the deviation of the results. The tested and estimated Ic in LN2 are 148 A and 143 A, respectively. When tested in the setup, the maximum temperature of the coil is controlled at 77 K and 40 K, and the I-V curves under both conditions are presented. It is found that the lower half coil that is closer to the stator has a smaller Ic due to a higher field level. The study is of significance to the development of HTS generators.
Original languageEnglish
Article number7828024
JournalIEEE Transactions on Applied Superconductivity
Volume27
Issue number4
Number of pages5
ISSN1051-8223
DOIs
Publication statusPublished - 2017
CitationsWeb of Science® Times Cited: No match on DOI

    Research areas

  • a.c. machines, Finite element analysis, High-temperature superconducting materials, Superconducting coils and magnets, Wind power plants, barium compounds, copper compounds, finite element analysis, high-temperature superconductors, iron alloys, nickel alloys, superconducting coils, turbogenerators, wind turbines, yttrium compounds, wind turbine generator setup, HTS wind turbine generator, Denmark, HTS coil, YBCO tapes, iron core, finite-element simulation, I–V curves, full-size high-temperature superconducting coil, full-size stationary experimental setup, pole pair segment, HTS-GEN project, magnetic environment, power 2 MW, current 148 A, current 143 A, temperature 77 K to 40 K, FeNi9, YBCO

Download statistics

No data available

ID: 130603912