Design, Prototyping, and Analysis of a Novel Modular Permanent Magnet Transverse Flux Disk Generator

Publication: Research - peer-reviewJournal article – Annual report year: 2011



View graph of relations

This paper presents the design, prototyping, and analysis of a novel modular transverse flux permanent magnet disk generator. The disk-shaped structure simplifies the construction procedure by using laminated steel sheets. To reduce output harmonics, the excitation of the generator is done by circular flat shaped Nd-Fe-B permanent magnets. First, a typical low power generator is designed, and then partially optimized. The optimization objective is to find an inner radius which maximizes the power factor, the output power to mass ratio and the efficiency. The generator equivalent circuit parameters are computed by three dimensional finite element analyses. The simulation results show that the power factor of the proposed structure is considerably greater than the power factor previously reported for other transverse flux permanent magnet generator structures. To verify the simulation results, a prototype has been constructed and tested. The experimental results are in good agreement with simulation results.
Original languageEnglish
JournalI E E E Transactions on Magnetics
Issue number4
Pages (from-to)722-780
StatePublished - 2011

Bibliographical note

Copyright 2010 IEEE. Personal use of this material is permitted. However, permission to reprint/republish this material for advertising or promotional purposes or for creating new collective works for resale or redistribution to servers or lists, or to reuse any copyrighted component of this work in other works must be obtained from the IEEE.

CitationsWeb of Science® Times Cited: 32


  • Prototype, Transverse flux generator, Finite element analyses, Disk-shaped structure, Power factor
Download as:
Download as PDF
Select render style:
Download as HTML
Select render style:
Download as Word
Select render style:

Download statistics

No data available

ID: 5659103